Input Doubler– Input #1 or #2
With our 2-device doubler cable, you can double up your PumpAlarm sensors in device inputs 1 and/or input 2 allowing you to plug 2 PumpAlarm sensors into one input. The male end of the splitter connects to the device and then has two female connectors to accept two PumpAlarm accessory devices, or cables, with the mating connectors.
The PumpAlarm 4G cellular transmitter accepts only a factory supplied, small clip-in cable terminal. This cable allows connection of any pumpalarm.com accessory devices to the pumpalarm.com clip-in sensor port.
Great for situations where you want to use a float switch and water detector together to monitor for water on a single input. In this example, the float switch would be connected to one side of the doubler mating connector, and the floor water sensor would be connected to the other mating connector. This configuration uses only a single input on the pumplarm.com cellular transmitter. CAUTION: whereas you can use this doubling cable to connect two sensors into one input, if you receive an alert from this alarm channel, it will be a “general water alert” indicating that one or the other sensor is in alarm, but you don’t know which one it is until visually inspected.
Our inputs can be customized to fit a range of applications. Through a simple text message, you can add a custom "input name" and adjust normally open/closed for each of our inputs. You may even set the alarm delay (1-999 seconds) to fit your specific application.
DO NOT APPLY EXTERNAL POWER TO THESE WIRES OR PRODUCT DAMAGE WILL OCCUR, AND WARRANTY IS VOID.
What’s Included:
- 1 – 5.5 in. adapter cable
- 1 Year Warranty