This rugged dual float switch is designed to be used primarily in residential, commercial and rental unit sump pump basins to alert the property owner of an excessively high water level before water spills out of the basin and onto the basement floor. Must be installed inside the basin above the normal water operating level, and can be quickly strapped to your sump pump discharge pipe.

Use the extension antenna when you have a weak cellular signal, and the signal needs to be improved. Our extension antenna is mounted remotely from the cellular transmitter using the supplied extension coaxial cable and has been designed to provide cost-effective coverage for you. It’s designed for wall, pipe, or mast mounting and is weatherproof, allowing the device to reap the benefits of an antenna mounted in an elevated location where the signal is strongest.

The rugged sewage ejector pit switch is designed to be used primarily in residential, commercial, and rental unit sewage ejector pump basins to alert the property owner of an excessively high black water level before water spills out of the basin and onto the basement floor. 6' cable length that plugs into input #3 & #4 on the PumpAlarm Unit.

The floor water sensor is a conductivity sensing device that can detect when water bridges the gap between the two stainless steel tabs on the sensor. Lay it on the floor in a mechanical room in commercial, residential, and rental applications to get early notification of a leaking hot water heater, leaking pipe, overflowing pit, or any other device which could leak and cause water damage. Typical applications include floors, under refrigerators, cabinets, drain pans, weep holes, and aquariums.

The micro float switch is great for applications where you desire to know of a high water level condition in a small tank or sump pump basin, in commercial, residential, and rental applications, and there is not water splashing or vibration present. Typical applications include sump pits, weep holes, aquariums, and bilge pump monitoring for boats.

The micro float switch is great for applications where you desire to know of a high water level condition in a small tank or sump pump basin, in commercial, residential, and rental applications, and there is not splashing water or vibration present. For more turbulent water applications, use our rugged dual float switch. Typical applications include sump pits, weep holes, aquariums, and bilge pump monitoring for boats. This product is identical to our other micro float, but has a longer cable for applications requiring the sensor to be mounted remote from the cellular transmitter.

With our 2-device doubler cable, you can double up your PumpAlarm sensors in device inputs 1 and/or input 2 allowing you to plug 2 PumpAlarm sensors into one input. The male end of the splitter connects to the device and then has two female connectors to accept two PumpAlarm accessory devices, or cables, with the mating connectors.

Our reliable 15' Input Cable can be used to add your own normally open/closed unpowered, dry contact sensors.

This 3-pin splitter can be used to convert inputs 3 and 4 into two, individually wired 2-pin inputs. Great for situations where you want to use a float switch and water detector together to monitor for water and have another use for inputs 1 and 2 for other sensors and/or detectors.

Our extension antenna has been designed to provide cost-effective coverage for your PumpAlarm.com 4G device. It’s designed for wall or mast mounting and is weatherproof, allowing the device to reap the benefits of an antenna mounted in an elevated or external location where the signal is strongest. This extension antenna is only compatible with devices ordered prior to October 16th, 2022. We have changed the antenna connector on devices and this item is not compatible with devices ordered after October 16th, 2022. If you have any questions, please contact our support at 888-454-5051.